ePLA-LW
ePLA-LW
A material specially developed for aeromodelling. The interlayer bonding is stable, and the foaming rate and strength can be controlled by adjusting the printing temperature. Using active foaming technology to achieve lightweight, low-density PLA parts, the foaming volume ratio is 220%, and the density is as low as 0.54g/cm3. Foaming makes the layered pattern almost invisible, and the surface of the printed item is matte and delicate. Under the same model and at the same speed, the lightweight PLA enables the model aircraft to have a lighter wing load and a lower stall speed, which can greatly improve the performance of the model aircraft.
Density as low as 0.54g/cm3
Foaming volume ratio 220%
Free adjustment of strength and foaming ratio
Excellent matte surface effect
Good interlayer adhesion
Easy to paint
Excellent printability
A material specially developed for aeromodelling. The interlayer bonding is stable, and the foaming rate and strength can be controlled by adjusting the printing temperature. Using active foaming technology to achieve lightweight, low-density PLA parts, the foaming volume ratio is 220%, and the density is as low as 0.54g/cm3. Foaming makes the layered pattern almost invisible, and the surface of the printed item is matte and delicate. Under the same model and at the same speed, the lightweight PLA enables the model aircraft to have a lighter wing load and a lower stall speed, which can greatly improve the performance of the model aircraft.
| Filament Properties Table | |
|---|---|
| 3D PRINTING FILAMENT | ePLA-LW |
| Density(g/cm3) | 1.2 |
| Heat Distortion Temp(℃,0.45MPa) | 53 |
| Melt Flow Index(g/10min) | 8.1(190℃/2.16kg) |
| Tensile Strength(MPa) | 32.2 |
| Elongation at Break(%) | 68.9 |
| Flexural Strength(MPa) | 41.31 |
| Flexural Modulus(MPa) | 1701 |
| IZOD Impact Strength(kJ/㎡) | 8.58 |
| Durability | 4/10 |
| Printability | 9/10 |
| Recommended printing parameters | |
| Extruder Temperature(℃) | 190 – 270℃ |
| Bed temperature(℃) | 45 – 60°C |
| Fan Speed | 100% |
| Printing Speed | 40 – 100mm/s |
| Heated Bed | Optional |
| Recommended Build Surfaces | Masking paper, PVP solid glue, PEI |
Submit Your Review
Required fields are marked *
John Doe March 22, 2021 at 1:54 pm
pellentesque habitant morbi tristique senectus et. In dictum non consectetur a erat. Nunc ultrices eros in cursus turpis massa tincidunt ante in nibh mauris cursus mattis. Cras ornare arcu dui vivamus arcu felis bibendum ut tristique.